首 页 微软 HP 思科 Oracle IBM SUN 打折信息 培训信息 其它
首页 >> 认证考试资讯网 >> 打折信息 >> 正文      

CCIE考试试题(2)

来源: 点击数:   录入时间:07-01-25 15:52:43

Question 1 How do you tell the IOS to display addresses with CIDR-style bitcount notation (e.g., 192.168.1.0/24) rather than traditional subnet masks (e.g., 192.168.1.0 255.255.255.0)? A. In configuration mode, enter ip classless B. In exec mode, enter term ip netmask b C. In configuration mode, enter term ip netmask b D. Bitcount notation is the default Question 2 What commands/functions are needed before you can compare logs between two routers? A. service timestamps B. ntp running C. terminal monitor D. debug Question 3 Assume you have telnetted into a router, and are talking on the telephone to another network engineer at a remote router. At the command prompt, you enter show version and get perfectly reasonable output. Next, you enter debug ip icmp and ask your partner to ping your router. She reports a successful ping, but you see no debug output. What is the most likely reason for your apparently inconsistent information? A. An access group on the virtual terminal line points to an access list that denies icmp echo respons B. An access class on the virtual terminal line points to an access list that denies icmp echo response C. logging buffered has not been configured D. terminal monitor was not entered in exec mode Question 4 Which command(s) will display layer 2 traffic volume? A. On a router, show interface B. On a C5000 family switch, show mac C. On a router, show ip interface D. On a C5000 family switch, show port Question 5 Select the initial forwarding mode(s) to all destinations, regardless of the mode set on the interface statement. A. Process switching on the 2500 through 4000 B. Fast switching on all platforms C. Process switching on all platforms D. Silicon switching on the 7000 Question 6 Which choice shows two techniques which cause the same filtering? A. ip route 192.168.0.0 255.255.255.0 null0 access-list 100 deny any 192.168.0.0 0.0.0.255 B. ip route 192.168.0.0 255.255.255.0 null0 access-list 10 deny 192.168.0.0 0.0.0.255 C. ip route 192.168.0.0 255.255.255.0 loopback0 access-list 100 deny any 192.168.0.0 0.0.0.255 D. ip route 192.168.0.0 255.255.255.0 null0 access-list 100 deny 192.168.0.0 0.0.0.255 any Question 7 What exec mode command displays the value of the configuration register that will be used at the next reboot? A. show boot B. show version C. boot system flash D. config-register Question 8 What choices make up the minimum set of password-related commands that must be defined before you can configure a router through a telnet session? A. service password encryption B. enable secret C. password under line vty D. enable password Question 9 In a routed environment, information at what OSI layer(s) is necessary to determine whether connectivity exists between two processes in end hosts? A. Application B. Transport C. Network D. Data link Question 10 In distributed switching, where are the two major components of routing implemented? A. Path determination and packet forwarding both run in special-purpose processors. An ASIC on the VIP or NFFC mirrors the processing in the main route processor. A. From a DHCP server B. From a GNS server C. Algorithmically, from local configuration of the network and its active MAC address D. Algorithmically, by combining its active MAC address with a network prefix learned by listening to router broadcasts Question 14 Select the statements that are true regarding Switched Multimedia Data Service (SMDS) and IEEE 802.6. A. 802.6 was developed as a general Metropolitan Area Network (MAN) that supported isochronous services such as voice and video, as well as data traffic. B. SMDS is a multilayer protocol stack that is a data-only subset of 802.6. C. 802.6 is intended for user access to networks. D. The SMDS Interface Protocol (SIP) layer 3 protocol is IP Question 15 If a serial medium is both slow and has a high error rate, in what ways could you optimize throughput? A. Reduce the packet size to minimize the amount of data to be retransmitted on error B. Use link-by-link rather than end-to-end retransmission C. Increase the TCP window size D. Use a small window size 本新闻共2页,当前在第1页  1  2  
·上一篇文章:
·下一篇文章:
发送好友:发送给好友 | 加入收藏:加入收藏夹 责任编辑:admin  文章作者:  
   
发表评论  
版权声明:除部分特别声明不要转载,或者授权我站独家播发的文章外,大家可以自由转载我站点的原创文章,但原作者和来自我站的链接必须保留(非我站原创的,按照原来自一节,自行链接)。文章版权归我站和作者共有
转载要求转载之图片、文件,链接请不要盗链到本站,且不准打上各自站点的水印,亦不能抹去我站点水印。
 

   

热点资讯

最新资讯

[ciscoexam]  誉天IT教育集团(武汉专

[ciscoexam]  誉天IT教育集团(武汉专

[ciscoexam]  誉天IT教育集团(武汉专

[ciscoexam]  誉天IT教育集团(武汉专

[ciscoexam]  誉天IT教育集团(武汉专

[ciscoexam]  誉天IT教育集团(武汉专

[ciscoexam]  誉天IT教育集团(武汉专

[ciscoexam]  誉天IT教育集团(武汉专

[ciscoexam]  誉天IT教育集团(武汉专

[ciscoexam]  誉天IT教育集团(武汉专


Advanced 中国婚庆 cisco考试站 21seo seo天空 私募基金管理网

Copyright © 2007 www.TESTZONE.org Corporation, All Rights Reserved 我要啦免费统计